Process:
Firstly, I created the base of the wash board by using the plane polygon. After doing so, I created the scrubbing area using the extruding function after selecting the edges of the board.
Secondly, I created the sides and the top part by just using the square polygon and scaling it to fit the board. Using the bevel tool to round the sides and my washing board is completed.
Reflections:
The washing board was the easiest out of all the exercise that were given in this week!
The only "hard" part was the middle part, which was the washing area. The scrubbing area I mean. Enjoyed doing this exercise!
No comments:
Post a Comment